- Headstock

Glue 2mm maple and 0.5mm rosewood on top. Cut slots and saw veneer perpendicularly to neck to fit the nut. Drill tuner holes and shape the headstock.




Comments

Post a Comment

Popular posts from this blog

#4 First mountain dulcimer (19 June 2021)

Image
Mountain dulcimer Scale 520mm Blond shellac Bone nut & saddle Sapele top and sides Padauk and Sapele back Beech fingerboard and neck Bone nut and saddle Lumber Bending sides Forming the neck Assembly back, sides and neck Linings Fingerboard scoop, 520mm scale f holes Tap tone 160Hz 520mm scale fret positions Ready to box up Box up Installed tuners French polished, install bone nut and saddle
Read more

3/4 Classical Guitar #6

Image
Size Body length 423mm, Upper bout width 230mm, Waist width 197 mm, Lower bout width 330mm, Side 80mm 580mm scale Top Englemann spruce 141.3g Back Khaya  Sides Khaya Neck Sapele Bridge Padauk 149g Fingerboard Teak Based on Torres FE19 Shaping the heel. The headstock The brace pattern Cutting the soundhole Gluing the braces Top and back braces Top frequency profile, 221 Hz Back frequency profile 105 Hz Bending sides with hot iron Cased up Paduak bridge Marking off teak fingerboard, 580mm scale length Ebony fret markers Shaping the neck after mounting the fingerboard Ready for French polish Paduak bridge with bone saddle and 12 hole bone reinforced tie block French polishing
Read more

Send private message

Name

Email *

Message *